[donandal]

Thanks everyone,

I am going to try and post in the order that things go back on, so
here is this weeks progress.

Before the cab went back on, I installed the engine harness. Plugged
it all in and tossed the rest on top of the engine.

I built this skid plate to protect the oil pan. Since the factory cats
were just about as low as the pan I just stayed with the factory
truck pan. The skid plate frame is 1/8th wall 1" square tubing. The
plate itself is .080 brushed stainless.steel.

It hangs just about 1/8 inch below the bottom of the pan.