Quote:
Originally Posted by toddoky
The manifold on the project truck was the Hi-ram, you shouldn't have any problems fitting it with your mounts either.
Posted via Mobile Device
|
Toddoky , Just wanted to give a update on the hi ram intake . I have got my engine apart and decided to try to check clearence for the intake . I see the the intake is 12.3" tall at the highest point from the valley on the front . I stacked 2x4 on top of the valley cover to get 12" at the front . The hood would not close . Apparently the flat plates and stock stands and mounts must hold the engine up . I took one 2x4 off which made 11" tall and the hood would close with 1/4 to 3/8 clearance best I could tell . Just wanted to let you know for future reference .
I really wanted to run the high ram . The low rise is not a option for my engine upgrades and power level . The holley system was not out at the time I did my swap or I would have used it .
I look forward to getting my exhaust . I ordered the 3" system behind the rear wheels last month .