[Scott2]

Originally Posted by gottattooz

I painted the cowl cover with epoxy paint. Then it's on to the inner rocker panels.

But first, i had to get the Jeep out from between the posts of the lift. I couldn't open the back doors but a few inches. I can't put the transmission in neutral without battery power, and I've got the ecm and tcm out So I don't fry anything when I'm welding. So, summit racing to the rescue. I bought a set of wheel dollies to push it around the shop.

I drilled holes in the lip of the top off the rocker panel so I could weld the inner and outer panels together. I got the top rail and the bottom of the rocker welded up on the driver's side. I need to weld the floor Pan to the rocker and then repeat the same oh the passenger side.

-Josh

Duplicate