|
Re: Wheeeels
Quote:
Originally Posted by ShinyC10
So is there anything against running that set up and just putting a half inch spacer on the front?
With the specs you listed, there’s not really a large selection of wheels unless you have a $10,000 budget it seems. Wheels and tires I’m trying to stick around 4 to 4500 max.
|
Quote:
Originally Posted by SCOTI
They should 'fit' fine assuming stock width rear end housing & un-modded (narrowed) front arms.
|
Not sure why you would want the 1/2" spacer up front? The 8" wheel w/4.54bs works as is. Adding a spacer brings it closer to the fender lip which you won't want.
If anything, you might need a 1/2" spacer in the rear to clear the inner wall of the wheel tub and/or edge of the bed floor. My bet is it should clear w/o one.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|