The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Tim240Z · 07-01-2011, 12:40 PM

I just pulled all mine off yesterday. Apart from the few screws at the ends, I just used a very thin 2" wide scraper....it is thin enough to flex and I used it to push the side 'spring' clip tabs and just popped them out.....pretty easy once you get it going....I tried squeezing the clips from the inside, but it seemed a lot harder and more time consuming.....
Tim

07-01-2011, 12:40 PM	#2
Tim240Z Senior Member Join Date: Jan 2005 Location: LAX area, So Cal Posts: 499	Re: Burb upper trim removal I just pulled all mine off yesterday. Apart from the few screws at the ends, I just used a very thin 2" wide scraper....it is thin enough to flex and I used it to push the side 'spring' clip tabs and just popped them out.....pretty easy once you get it going....I tried squeezing the clips from the inside, but it seemed a lot harder and more time consuming..... Tim __________________ 1972 Suburban C20 454/TH700R4, eaton-corporate 4.10 (looking for 3.7) Sold: 71 Cheyenne 20 Installed a 99 5.7L L31/4L60E from Suburban 1500 (2005)