[KyleSeal]

Moving sloooowwwww this past weekend, but slow is good when working with sensitive gaps and pieces. Burned in the kick panel spot welds, with some of my favorite rosette welds (just to be covered up ), and then got the square nuts burned into the a-pillar piece and burned in the a-pillar fully. Moved onto the b-pillar piece (really nicely re-stamped by KeyParts if I may add), and neutralizing the rust in the cab corner's inside. While I waited for the phosphoric acid to do its work I ground down most of the welds on the inner rocker. I would imagine this week I will have the outer rocker fit, primered and welded in place.