The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

kda406 · 11-09-2020, 03:51 PM

Since I'm using the Suburban's factory lines between the MC and the proportioning valve, it seems unlikely that I could have them backwards - but I'm going to check!

I did not use the little tool in the valve when I've bled the brakes in the past. The truck always seemed to bleed just fine without installing that tool. But with that being said, something is wrong, so I'll bleed them again with that tool installed just in case.

Thanks for the suggestions. I've been beating my head against the wall and really needed some outside advice.

-Kyle

11-09-2020, 03:51 PM	#3
kda406 Registered User Join Date: Apr 2013 Location: Atlanta, GA, USA Posts: 3	Re: C20 Rear Lockup after Disc Conversion Since I'm using the Suburban's factory lines between the MC and the proportioning valve, it seems unlikely that I could have them backwards - but I'm going to check! I did not use the little tool in the valve when I've bled the brakes in the past. The truck always seemed to bleed just fine without installing that tool. But with that being said, something is wrong, so I'll bleed them again with that tool installed just in case. Thanks for the suggestions. I've been beating my head against the wall and really needed some outside advice. -Kyle Last edited by kda406; 11-09-2020 at 04:03 PM.