Alright, another weekend of progress!
A few more components showed up in the mail. These are 1/4-20 rubber mounts with a 5/8" diameter body. They will be used to mount the Terminator X ECU.
This is an OE connector for the Ford Fusion fan. This will be used when the fan harness is built and integrated into the Terminator X.
New grommets came in for the airbox from the dealer!
I fabricated an ECU tray and installed the rubber mounts.
Tray and ECU installed! Wires were also routed during this time.
Next project, accessing the cooling fan. I picked up a mating connector for the fan at a junkyard, and picked up a PWM generator from Ebay. These cost less than $10 and will be a handy little piece for testing equipment in the future!
The test harness is made, and the fan works!
I've also made a video showing the PWM operation of the fan and the basic wiring needed to make it function!
https://www.youtube.com/watch?v=hMEX...ature=youtu.be
As shown here, it pushes a piece of paper very well!
I also made the dedicated battery connections for the Holley ECU.
And finally, here's the engine bay progress so far!
