Re: C20 long bed to short bed conversion - questions
Quote:
Originally Posted by 69Tom
Thanks. For your cuts, I assume you used a sawzall? I'm concerned about the precision on the curved cuts with it. However, I'm sure it's possible.
|
4" angle grinder & cut-off wheel. I made the rough cuts w/extra material as a fudge factor. That allowed straight cuts & then going back w/a flap disc to slowly dial in my curves. I laid out the lines first for the visual guide & used a template for the curves.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|