The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 67 DRGNWGN

**kev2809** · 08-12-2023, 08:34 PM

sooo, been a little busy lately. got the carpet fully in, got the seats all bolted down (need to make one more point of mounting for those rear seats), also wired up and made my rear speaker mounts. also replaced the damaged carrier bearing for a beefy billet one.

i took a peak of where about i ride at with the ride height, and im not sure if this is how far the splines should be out on the slip shaft..any thoughts?

08-12-2023, 08:34 PM	#1020
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,134	Re: Project 67 DRGNWGN - 67 Burban!! sooo, been a little busy lately. got the carpet fully in, got the seats all bolted down (need to make one more point of mounting for those rear seats), also wired up and made my rear speaker mounts. also replaced the damaged carrier bearing for a beefy billet one. i took a peak of where about i ride at with the ride height, and im not sure if this is how far the splines should be out on the slip shaft..any thoughts? Attached Images __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]