[68 C10 Driver]

A little more progress today. I decided to do a test fit of the dash and see how the new dash pad will look. The dash is just temporarily held in by the six bolts. I will also take the opportunity to get the dash and cab crimp weld around the window opening to realign as those curves are a bit off from cutting the dash out.

Additionally, the outer cowl panel is stripped. I noticed there are a few "pock" marks from the surface rust that was present. The wire brush only gets so much, so I used the Rust Mort to take care of the rust. I will sand the panel tomorrow and prime it after I weld up the antenna hole.