Quote:
Originally Posted by LEEVON
Check out my "how-to" in the FAQ truck tech 73-87. The main things I learned is that you need to use an anvil style cutter (one flat surface side) and the pre-cut kits are a poor fit. Your custom cuts will be tight and sealed well using the correct cutter.
https://67-72chevytrucks.com/vboard/...d.php?t=572074
|
Very Good ..thanks .I have copied all this you have shown and will dig it out and use it as my guide to doing the job when warmer weather comes again in my area,,
I was wondering about expansion of metal on the truck when one glues the strips on.. What I am getting at is should this be done on a in between hot and cold day ? Say about 70 degrees ..I may be over thinking this ?