[youngrodder]

I went over to my friend Zach's that is helping me modify my filler neck on my new tank. Like everything he does he took it over the top. My idea to modify the neck was quick and dirty. Zach's not so much. We cut out the existing filler. He then formed a new piece of metal and cut out the old filler neck in an effort to weld it in more straight up and down to match my previous tank. The tank will be wrapped up this week #nomoreleaks

I also started on the PITA headliner. My headliner will be made out of 1/16" black ABS plastic. I purchased a large roll of chipboard from Home Depot. This thick board used for wood flooring allows me to make templates of each of the headliner sections to use to cut the ABS. I got the rear piece cut, fine tuned and fit after a long fight. I will take pics of the ABS panel in place but this picture shows the chipboard to give you all an idea. 1 section down with 4 to go.

Oh and the bonus pick is a bagged ACME chassis with a Don Hardy LS motor for a customer of Zach's he is building. Its for a FO$% truck. The rear rims are 24' x 15". I'm helping him figure out how much to shorten the rear-end.

Thank you
Marc