Re: PO has me PO'd
Yesterday was a total fail trying to get the curved part of the gasket to seat, so I changed up, and attacked it from the gasket end, hoping the curve will fall in place,which it did. Most of the curve is in place, just have to change up the tool as it is too wide to seat the gasket in the curved area
This clamp was invaluable in keeping gasket in place
My plan is to let the windex dry, and grind down an old screwdriver and try tomorrow
16359498572501597310992686729244 by [url=https://www.flickr.com/photos/97391199@N06
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
Last edited by jaros44sr; 11-03-2021 at 10:40 AM.
|