[Grizz1963]

So I had planned on using one of the two arms bought to replace the welded up one.

So before work this morning at 07.00 I went down to the garage, pulled out the grinder and knot wheel.



Then today when ordering the bushes I realised that there are three different sizes on each end, making for a load of permutations.

So when I checked, the one end was 50mm and the new ones were 43mm but the ones fitted were 47mm so I would need to replace both arms in order to keep things uniform

Sp after work tonight I had to go do no 2 as well.



Not too bad.



Then painted them and left them hanging to dry overnight and for the next few days.



Followed by mowing the lawn.

Lets hope the bushes all come out without giving me a hernia.