[Kronald_70GMC]

Well now that those are done and mostly out of the way (still need to be installed) I decided to start playing around with my seats, console and behind seat audio box. I put in my driver's side seat on some blocking to get to a height and pitch that I'm happy with. Near as I can tell with measurements off my dad's truck, I've settled on stock height at the back, down an inch in the front and slid back as close to the rear panel as possible. This gives me just a bit more headroom as well as legroom since I am 6'-2". Once I had that established, I started creating the skeleton of my behind seat box. It will follow the same slope as the seatback until it hits a level line from the tip of the rear floor hump, then it will drop vertically till it hits the floor. I think that will look best.