The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 55.2-59 Has anybody here used a Chassis Engineering bolt-in crossmember on a Task Force?

dsraven · 10-16-2023, 04:04 PM

there was a fella on here awhile back who narrowed a square body cross member for under his truck. he also fabbed up his own control arms for the super low1 ton. it might be something that could be done but the steering center link would also have to be narrowed to match. could get involved with getting that done legally and safely. just a thought.if the wheelbase is the same you would also need to look at the ackerman angle to see if the steering geometry would be changed enough to think about.

10-16-2023, 04:04 PM	#39
dsraven Registered User Join Date: Nov 2010 Location: calgary alberta Posts: 7,839	Re: Has anybody here used a Chassis Engineering bolt-in crossmember on a Task Force? there was a fella on here awhile back who narrowed a square body cross member for under his truck. he also fabbed up his own control arms for the super low1 ton. it might be something that could be done but the steering center link would also have to be narrowed to match. could get involved with getting that done legally and safely. just a thought.if the wheelbase is the same you would also need to look at the ackerman angle to see if the steering geometry would be changed enough to think about.