Re: 700R4 build thread.
Separator Plate.
Use a TransGo 700-P separator plate, At less than $20....Using the old plate is pointless. The holes are optimized for stock-mild builds, If using a Shift kit....Follow the directions for hole sizes.
This Plate Fits ALL 700R4's, Depending on what year/model you have, A couple holes may need to be plugged. The Plate comes with 2 Aluminum Plugs. This is EASY to do, Place the plate on a smooth concrete floor, place the plug in the desired hole, With a Ball-Pein hammer whack the plug a few times (Do Not strike the Plate!!), This will expand the plug & seal the hole.
First, Identify what Valve Body you have,
1st design VB's have separate 1-2 TV & Low bushings (Has a Roll-Pin for the Low Range Bushing).
2nd design has a Combined 1-2 TV & Low bushing (No roll pin), If you have the 2nd design VB, Plug the Hole in the Pic.
If Trans has a Auxiliary Valve Body, Plug the other hole in the Pic.
|