Quote:
Originally Posted by biketopia
Is there absolutely zero tension on the bar? Heat is probably going to be you friend, or if you're replacing the lower control arm, cut it out of your way and just hammer the bar to get key all the way loose so you can reinstall everything.
|
Unfortunately I'm not planning on replacing the lower control arms, otherwise I probably would have gone that route already. I used heat on the keys and I think that's what helped break those loose-ish.
I have the control arms jacked up to remove their weight/torque from the torsion bar. Last time I did this was on an 88 or 89 truck but it was in the mid 90's so it hadn't had nearly the time to rust everything together as this one has. I really don't think it has been apart since the it left the factory. I'm almost positive the lower ball joints are original as are the lower control arm bushings. The only pieces that I know have been replaced are the sway-bar end links. If I can't get the torsion bars loose, I'll probably just press the new LBJs in and pay someone to do the bushings, which I'd rather not do.
One thing I did learn (remember?) working through this is to never comment to anyone on how well things are going. Right before I started on the torsion bars, I mentioned to my wife that it was going much smoother than I had anticipated. That was a mistake. 😅