|
Re: Question About Neutral Safety Switch and Van Tilt Column
I use the truck switch and install it on the lower end of the column in the same position as the truck columns. A slot is needed as well as welding in a "tab" that fits into the slotted tange on the truck switch. If you put the switch higher up on the column there are clearance issues.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end
1965 Impala SS 400 sbc, Muncie rock crusher
1966 Impala SS 396 bbc, TH 400
1969 El Camino, 350 sbc, TH 350
1971 Snowplow built on a Blazer frame
1972 GMC Short bed, stepside, TH 400, 427 BBC
|