Quote:
Originally Posted by AussieinNC
Almost
Your entry shows
0.004 x 3.9350 = 0.01574
0.0045 x 3.9350 = 0.177075
Should be
0.004 x 3.9350 = 0.01574
0.0045 x 3.9350 = 0.0177075
I would set ring end gap to 0.016 and be done with it....
Make sure you deburr the ends after gapping them...
 |
Oops must have been a typo.
So do you think I should gap all the rings the same? I think I read something about gaping the 2nd ring slightly larger?
(By the way this engine build is going to be pretty much stock, no turbo or any of that)