[Richard]

Cut panhard bracket off frame and made the modifcations for clearance of bar up travel. May be hard to see in pic, but it took some time. New steering shaft is cut and installed. PSC steering box is about 2 1/4 turns lock to lock. Can grind the stops if I need more turning radius. Made the hoop mounting points for frame. Started work on shock hoops. Cut them in half and made some bends to clear the steering shaft and locate the top forward a bit. Both sides are set. Next step to tack in place and modify the rear of hoop. Then make one piece again. Still working a lot. Hopefully more time this next week as I finished up a couple jobs at the shop.