The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**kwmech** · 05-13-2021, 05:46 PM

I'd lay a straight edge on it to verify flatness then use a cork gasket. If you have an '' inch pound torque wrench '' I'd take em to about 110

05-13-2021, 05:46 PM	#4
kwmech Senior Member Join Date: Mar 2003 Location: Colfax-California Posts: 8,393	Re: L6 250 12bolt valve cover I'd lay a straight edge on it to verify flatness then use a cork gasket. If you have an '' inch pound torque wrench '' I'd take em to about 110