The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - changing upper a-arm mount locations. Wanting input please

GEARBOXGARAGE · 07-24-2013, 06:48 PM

When Hotchkis created their upper A-Arms, they incorporated offset shafts (approximately 1/2") for better camber gain, much like what you are attempting by lowering your mounting point. Check out this photo of an install in progress, you can see how the ends of the shaft are offset from the centerline of the mounting point.

07-24-2013, 06:48 PM	#19
GEARBOXGARAGE Registered User Join Date: Sep 2011 Location: Sturgis, Michigan Posts: 509	Re: changing upper a-arm mount locations. Wanting input please When Hotchkis created their upper A-Arms, they incorporated offset shafts (approximately 1/2") for better camber gain, much like what you are attempting by lowering your mounting point. Check out this photo of an install in progress, you can see how the ends of the shaft are offset from the centerline of the mounting point. Attached Images Last edited by GEARBOXGARAGE; 07-24-2013 at 07:06 PM.