The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

PanelDeland · 10-20-2010, 05:37 PM

I did one long ago,so take this with a grain of salt.IIRC the yoke on the rear half slipped into the front half,then had a bolt thru the center holding it in.I think I had to remove the u-joint to remove the bolt so I could seperate the two shafts.

10-20-2010, 05:37 PM	#2
PanelDeland I am a Referee of life. Join Date: Jun 2000 Location: Greensboro N.C. Posts: 13,993	Re: Midshaft bearing Problem I did one long ago,so take this with a grain of salt.IIRC the yoke on the rear half slipped into the front half,then had a bolt thru the center holding it in.I think I had to remove the u-joint to remove the bolt so I could seperate the two shafts. __________________ The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil"