Quote:
Originally Posted by hotrod1
Lots of great ideas. Take a look at this pic - how would you run the cable(s) to the starter from a rear-mounted battery? Kind of close to the headers.
|
If the passengers side mirrors the drivers side where the header is, I would use cushion clamps along the inside of the frame, then cross over with a twisted standoff bracket with clamp from one of the torque converter dust shield bolts, come along the starter solenoid and connect with a 90 degree terminal for the positive. For negative I would do the same but use a double stud for one of the bellhousing bolts and ground there instead of the standoff and forward. All that assumes that the exhaust is routed below them far enough to be OK.