The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - LockDoc's "Low Budget", "Low Maintenance" Project Thread

**LockDoc** · 03-03-2022, 05:05 PM

-
Finished Mounting the cab lights today. I couldn't decide whether to mount the outboard ones straight or on an angle. After looking at some pictures on here I decided to mount them straight. I had one light that all of the chrome had come off of so I disassembled it and used it for the setup. Without the wire and rubber base on it, it was real easy to tell where the light fit the curvature of the roof the best.

The assemblies that are on there now are not the good ones. I used these to get all of the holes drilled and lights mounted, to make sure of my spacing. I will remove these and run the wiring and install the good ones tomorrow.

LockDoc

03-03-2022, 05:05 PM	#120
LockDoc The Older Generation Join Date: Aug 2006 Location: Montezuma, Iowa Posts: 25,332	Re: LockDoc's "Low Budget", "Low Maintenance" Project Thread - Finished Mounting the cab lights today. I couldn't decide whether to mount the outboard ones straight or on an angle. After looking at some pictures on here I decided to mount them straight. I had one light that all of the chrome had come off of so I disassembled it and used it for the setup. Without the wire and rubber base on it, it was real easy to tell where the light fit the curvature of the roof the best. The assemblies that are on there now are not the good ones. I used these to get all of the holes drilled and lights mounted, to make sure of my spacing. I will remove these and run the wiring and install the good ones tomorrow. LockDoc Attached Images __________________ Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 -