Re: Crossbreed
Got the steering issues worked out, pretty much had to redo all the po's work..
Decided to run wheel spacers for now. Ended up using a set of the adapter type, 1.5" up front and 2" in the rear.
Since I got the clearance I needed I drilled the knuckles out using a 7/8 step bit and used some tapered bushings from barnes to convert back to tie rod ends instead of heim joints. The heims we're 7/8-14 tpi vs the tie rod ends 7/8-18 tpi so I had to cut off the tie rod tube ends and weld on new ones with the correct thread.
|