Part Time Pulling Truck Build
Thought I would join the crowd and start a build thread, although it actually wont be an entire build thread as I already have a good body and interior, more of a frame build for the rest the parts. I am in the process of building a sled pulling truck that I can still drive on the weekends. Any input from current or past pullers is more than welcome as this is all new to me.
Completed:
Axles:
Dana 60 front, 4.56 gears and a full spool, with crossover and high steer
14 bolt rear with 4.56 gears and a Detroit Locker
Suspension:
6 EZ Ride front springs with a 1 zero rate block and 6 degreee shim
6 Rear springs with rolled spring perches
Bilstein 7100 remote reservoir shocks at all four corners
Hitch:
Reese hitch with added 2 tubing for additional bracing
In Progress:
Traction Bars : 2 .25 wall DOM pipe with 1 heims on each end
(Have all the material just need to weld up)
Suspension Blocks: Need to come up with a design
Frame: In the process of boxing from the transfer case back
Motor Mounts: looking for an aftermarket crossmember???
Front hitch for weight bracket: Need a design
Goals are for all the welding on the frame to be completed by the end of Jan. so it can get powdercoated.
Want to have entire truck back on the road by April!!!
Have a lot more to add just not the time right now
..need to get back to work
The above was the thread I started in the general catagory but though I would move it to the 4x4 section, probably more interest in here, maybe....
any how attached are a couple updated pictures
__________________
1972 K5 Build - plans - LS3-6L80e-One Tons.....
1971 CREWMAX Build.....at body shop for couple more years
|