The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

og350 · 02-25-2009, 01:10 AM

ok a few questions on your build....
did you make your own cross over and high steer or it is a kit? i am looking to do that soon. second what are you going to do with your shift linkage? i have a th400 with stock linkages and the last pull i did i was holding it down into first and the tranny wanted to shift up so bad when i bogged down at the end that it pushed the linkage off the side of the tranny. just wondering if that has happened to anyone else. i was looking at the direct bolt on lokar kits but didnt know if they will hold up..

02-25-2009, 01:10 AM	#24
og350 Registered User Join Date: Apr 2008 Location: river falls, Wisconsin Posts: 236	Re: Part Time Pulling Truck Build ok a few questions on your build.... did you make your own cross over and high steer or it is a kit? i am looking to do that soon. second what are you going to do with your shift linkage? i have a th400 with stock linkages and the last pull i did i was holding it down into first and the tranny wanted to shift up so bad when i bogged down at the end that it pushed the linkage off the side of the tranny. just wondering if that has happened to anyone else. i was looking at the direct bolt on lokar kits but didnt know if they will hold up..