View Single Post
Old 07-13-2014, 05:55 PM   #12
Registered User
Join Date: Jul 2011
Location: Western Canada
Posts: 238
Re: Bucket seat conversion using bench seat brackets how to

Originally Posted by 1969stepside View Post
can you tell me how and where you decided to drill your holes in the floor to go from bench to buckets? did u use the existing holes on the outside and then drill where the other ones would go?
It wasn't bad at all. I just used the existing driver's side bench seat bracket holes. I had to drill 4 new holes for the drivers side bracket closest to the console. It was easy enough with the other bracket to reference from.
For the passenger side just a little correction, it was not direct bolt in. 3 new holes had to be drilled. Only the existing outside front could be used.

Here's a good link for bolt hole locations:
Beaumont@ is offline