Re: 67 Blinkers not working but hazards do
Did some wire tracing last night and found that the pink wire going to those fuses was fed by the ignition switch in the Run position. After a lot of terminal cleaning on the fuse block i was able to get good continuity from the ignition switch to the fuse block.
Dirty old terminals can really mess up a circuit. Both the hazards and signal blinkers are functioning properly.
Thanks again to everyone.
__________________
67 C10 Fleetside SOLD
67 C10 SWB Fleetside
67 C20 Fleetside
68 C10 Fleetside
68 C20 Fleetside SOLD
72 k20
Pay Pal: Grant.Furneaux@gmail.com
|