The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*blackedoutharley* · 08-15-2011, 06:37 PM

If the cylinders are round with no ridge at the top they should be able to be honed with no problems... Are they just bare blocks or do they have pistons, crank etc?

If complete, you basically would do a ring and bearing job and have a fresh motor although one that is at the end of its life.

Its probably cheaper to buy a block now than to sleeve what you have.

08-15-2011, 06:37 PM	#3
blackedoutharley Account Suspended Join Date: Jul 2007 Location: Plumas Lake, Ca. Posts: 1,009	Re: 350 block with 060 over bore If the cylinders are round with no ridge at the top they should be able to be honed with no problems... Are they just bare blocks or do they have pistons, crank etc? If complete, you basically would do a ring and bearing job and have a fresh motor although one that is at the end of its life. Its probably cheaper to buy a block now than to sleeve what you have.