Por 15 need help
Doing frame off on the K5 - everything besides the axles is getting powdercoated - didn't want to do the axle because I didn't want to pull the gear set out ( have no clue how to reset up).
Anyhow - full axle tear down so decided to paint with POR 15 - cleaned everything with their degreaser/clean - then metal prepped
coated first coat with POR 15 rust preventer then went over that with the POR high build primer - to flatten out some of the brush marks left from the first coat - it worked and looks good
Issue - today went to put their TOP COAT on but its so thick - consistency was between a tar and a thick latex paint. Couldn't get the paint to lay flat and not have runs in it. Looked horrible so used Acetone to remove what I could.
Then tried to thin it with Xylene - that thinned it but then it wouldn't cover and still had tons of runs in it.
At this point I want to throw that stuff away and go a different route on the top coat
WAHT CAN I DO ....
thanks guys
__________________
1972 K5 Build - plans - LS3-6L80e-One Tons.....
1971 CREWMAX Build.....at body shop for couple more years
|