|
Re: Used Parts Build
Quote:
Originally Posted by tinydb84
Attempt two!
Learned a lot (or more accurately-learned that I don't know a lot) with this little mount I made. Most importantly I am no where near as strong as I thought I was...The bracket is made out of .100 stainless. Even with the notches cut I ended up using a cut off wheel to thin out the areas that weren't notched. I didn't account for bend radius or the distortion in the areas where the bend would occur. it still came out significantly better than if I was to try to make it by hand but there is definitely a learning curve to this stuff as well. I think when I get more space I am going to invest in a finger brake. |
Did you spec the 'cut line' dimension? If so, what was it?
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|