Re: LS Swap: Introduction, newbie, planning...
Quote:
Originally Posted by Davidf
Update:
In tank fuel pump is fabricated and mounted in tank. All fuel lines run...fuel system complete.
[IMG] [/IMG]
All under hood wiring is complete and a/c lines fabricated and connected.
Left to complete: exhaust, complete in-cab wiring, install volt meter gauge, speedometer drive.
|
Where did you get the fittings for the wires to come out of your bulkhead? I've seen some folks terminate to studs, but I'd rather just run my wires through the bulkhead. Just not sure the best way to seal up the holes or what fittings to use.
Thanks.
__________________
"Green Monster" (Red Sox fan)
1970 GMC survivor, 350/200 4R, 3.42 rear gears, 2.5/4 drop, ECE disc brake conversion, powder coated suspension
|