|
Re: No start issue
Did some late night testing..
I back pinned the ecm plug on pin #2 ,light green wire..turned key on and I have 12v there..
Then I back pinned #12, dark blue wire..and started bumping the engine over..
it cycles 12v-0v-12v-0v-12v-0v...
So I'm assuming it's getting a crank signal..
Then went back and redid the multimeter test on my old sensor..and it is working..not sure what I did wrong the 1st time.. but it pulses correctly..
I really hate wiring..haha
|