Quote:
Originally Posted by MikeB
So, you used a u-joint to replace the upper coupler, the one with rubber in it? And then you slid the smaller DD shaft inside the larger shaft until you got the proper length? Did you then secure the two shafts to keep them from rattling? And how about the flexibility needed to disengage the lower shaft from the rag joint coupler?
OK, I think I understand that. But won't the inner shaft now be loose inside the outer shaft?
|
Here's a link the joint I used..
https://www.borgeson.com/xcart/produ...1&cat=2&page=1