so I picked up my $75 in seals and bearings from napa the other day. The Junkyard 12 bolt posi was leaking oil out the pinion like a New Orleans levee....
The corp 10 front axle had crusty needle bearings and bad seals too....
Also a pic of the read add-a-leaf installed. Added 1.5" to the leaf pac before installation.
New rea wheel studs where in order since I could only get 6 turns on the lugs with the MT's installed. These are 1/4 longer. Whats the best way to install? press, or just tighten down a lug nut to pull it tight?