|
Re: Cgt project
Quote:
Originally Posted by vet57air
I have my 325/35/22 tires in place. They are pretty big at 31" tall. Pictured is the min clearance I could get away with, about 3/8". Should have a bit more maybe. I don't really like the way they look from the outside. To far in. Thinking I will cut the box side flange back, to bring the tire farther out. Anyone do this? I'm thinking I would cut back to 1/4" and weld some 1/4 x 1/2 FB along the seam to make up for lost strength. I could then move the tire out another 1" or so and end up with 1/2- 5/8" clearance
|
That's about spot on where mine is & I share the same concern of it being tucked too much. The issue w/trimming the inner bedside flange is you can't trim much (maybe .675?). Even @ that, I would want to reinforce it somehow. I am still contemplating possibilities....
What wheel widths did you ultimately purchase?
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 03-20-2020 at 03:54 PM.
|