I picked up a new wiper motor because the old one quit working.
Turns out the new motor didn’t solve the issue, nor did a new switch. After a day of troubleshooting, it turns out the blue wires were swapped in the new harness!
New wiper motor in and all wires where they are supposed to be!
Installed all new wiper washer lines and filled the tank!
Next up, finally rebuilding the front axle!
Hub and rotor removed
Rotor and bearings are well worn due to improper hub nut adjustments.
The calipers are showing their age also
Drivers side!
Even the spindles are damaged beyond repair from the loose bearings
U-joints are completely shot
Everything all apart!
Time for some new parts! Rotors and bearings
New calipers and pads
Removed the carrier and old axle seals, cleaned the housing.
New axle seals!
Pressing the new seals in! This tool was worth every penny
Carrier reinstalled
New spindles
New hub nut kit
New U-joints installed in the axle shafts
New ball joints installed in the knuckle
New rotor and caliper installed
Hub installed
Ball joints installed in passenger side knuckle
Knuckle installed to axle housing
Axle shaft and new spindle installed
Backing plate, rotor, and caliper installed.
Also installed the new trailer brake controller under the dash.
