[77ChevySharkBite]

Well guys, I know it's been a long time since this has been updated but the project is starting to pick up slowly, so here's some pictures. What we did is of course pulled the frame out.



Just some pictures of how everything is looking right now.







Here's the correct transmission support that's supposed to be with the truck, PO ghetto rigged one up.



The one the PO made



Here's the comparison between the supposed to be tranny mount, and the PO ghetto rigged transmission support.



Does anyone know what these numbers are?







The truck when it was originally built was made with a I-6 I'm guess it was a 250cid? But here's the take the I-6 mounts being removed.





Here's the correct engine mounting hardware for the sbc




It seems as if I didn't take any pictures of it, but we also wire wheeled some of the engine mount hardware, and we also wire wheeled on the frame where the engine mount bracket goes. Right now he's wanting to get the frame ready for sanding blasting, so that it can start being built back up again.