View Single Post
Old 04-17-2021, 07:50 PM   #50
nsb29
Senior Member
 
nsb29's Avatar
 
Join Date: Feb 2014
Location: new smyrna beach fl / 29 palms cal
Posts: 1,727
Re: Roof patch causing warp / oil canning

I have used panel bond several times in positions where if I could have gotten in there to clamp it I could’ve welded it, I used panel bond when I put the big back window in my 65 by making sure that the two panels lined up properly and touching each other All the way across I installed the inner cab Using the panel bond and clamped the cab around the door opening and window The panel bond that squeezed out of the joint was wiped off leaving a perfect seem and then spot welded the rest.
Just for kicks I have taken some of the leftover panel bond and pressed couple pieces of scrap together it’s stronger than a weld you can’t rip it apart
__________________
Hand made A/C vent manifolds for 64-66 trucks adapts any aftermarket A/C to OEM vent

Last edited by nsb29; 04-17-2021 at 07:59 PM.
nsb29 is offline   Reply With Quote