Re: Project 30 Be Low
So today I removed the coil springs and lowered it down to the bump stops to see what the frame height would be off the ground. On the bumps it’s still 10 inches off the ground with stock crossmember. So if my math is correct a 2 1/2 inch drop spindle and an inch and a half cut out of the stock crossmember it’s only gonna get me down to about 6 inches of frame off the ground. Adding a drop ‘Member is going to get me a heck of a lot closer to the ground.
Last edited by Mike Bradbury; 04-17-2022 at 05:04 PM.
|