[ItWillBeSlow]

Thanks for the detailed response and the additional info Robert.

The antenna cable was fished through to drivers pillar and the hole did not go through the inner panel. My truck does not have a cargo light or any other way to get behind this patch.

In my first attempt, I definitely had some gaps in my patch, and was blowing holes and turned my welder heat and wire speed down low, so it seems I had a major offense in at least two categories.

I am not familiar with planishing techniques, is this something I will need to do if I can’t get behind the patch?

Once I get my circle patch cut, is there a recommendation for what order to tack in?