Quote:
Originally Posted by QBRacing
@57fleetsideC4
The bushes weren't that hard. I bought a cheap 160nzd bench press. Made up a base plate from some 50mm board and pushed the middle section of the bushes out, then the bush. After that it was a matter of greasing and pushing in by hand.
@dsraven
I hear ya but I trust my new panelbeater (more than the last one at least) and what you say about panels makes sense... they are a dam truck after all. Still plan to shorten the bottom of the door while doing the patches as you cant see both sides at the same time and what's 12mm between friends.
Q
|
Thanks for the update on the control arms. They don't look to hard to do. I am pretty far away from doing this but always gathering information. Steve