[Grizz1963]

Originally Posted by Just call me Sean

If they do operate as the turn signals then someone had to alter the wiring. Brake and turn signals go through the turn signal switch (I think it's called the multi function switch as it also controls the hazard lights.) It separates front from back and left from right so the fronts don't light when you step on the brake but they do when you turn on the turn signal. So unless there is some kind of signal splitter (we have them to connect single bulb red trailer lights to euro style car lights) then the brake light wires might be cut from the turn signal switch and attached directly to the brake switch. Then the cut switch wires would have wires ran to each reverse light, and the reverse light wire would be moved to the new reverse light.

Complete Greek to me Sean, I would call a friend to figure the stuff out.

Originally Posted by Just call me Sean

Thinking about it more, without having to run any wires, they could have used the reverse light wire for the brake lights, the brake light wires for the turn signals, and you wouldn't have any reverse lights. Most of the modifications would be under the dashboard.

Under dash mods are even more of a problem for me, but maybe whoever does look at it will be able to figure something out.




The Fleetside badges on the sides of the truck have been a thorn in my side from day one, mainly because they are both drilled through in 4 places.

I am kinda ambivalent about the aesthetic, but the holes bug the living hell out of me.

And I will not be welding them up or closing them, and repainting the whole truck.

So making the best of it came together today.

Chatting with Fil in Cambridge who fetched the Rezin Rockit, after his offer of a new rear bed mat for the truck, his suggestion of a tongue in cheek name for the truck resonated, and set in motion some work and research

Originally Posted by sparkplug

We need to find a name for the truck, remove the 'fleet side' badges and cast a new badge with the truck's name on it....

Given the lovely engine burble I'm voting for "XXXXXXXXXXXXXXX"

Jolity aside - your last post reminded me that I still have plenty of G-Floor diamond pattern flooring left over if you'd like it for the truck bed.

3.1mm thick polyvinyl (waterproof, resistant to oil, salt and even battery acid) 2.3m wide and I can cut the roll to length

Looks a bit like this



It's actually a lighter grey than that photo suggests. Slight blue tint to it - a bit like battleship grey. I can send a sample piece if you want to see the colour properly against the van before lopping off a big chunk?

40mm high



400mm long



Wedge shaped and flat faced, pic taken tonight as part of the planning.




So the attention turned to CraigRK and Andy in Tulsa Oklahoma, both capable 3D printers.

Could they print and Cast me a new set of silly custom side badges to fit over the holes with some double sided tape.


Something along this style.

Of course it may be a divider, but hey, life is interesting.



Let’s see where this goes.

.PS: Fill said that he likes the Rumble of the V6, lets see if it can be improved if I can find an electric cutout switch for the exhaust, fitted before the muffler/silencer.

Could be a nice sound................... A BIT LIKE THIS


https://youtu.be/Fwf1M-irmG0


Another one

https://youtu.be/aVbvZmJ82uY


Just enough of an antisocial tone.