Re: my '59 short bed build
Quote:
Originally Posted by mr48chev
Ideally the front pivot point on that type of setup is at the same spot the front U joint on the driveshaft on a one piece drive shaft is or the center U joint if you have a two piece drive shaft.
Functioning the same way the torque arms on 67/72 Chevy trucks or the torque arm on at least one generation of Camaros do.
|
It will be very close. The crossmember I want to tie into for the frame mount is right at the tail end of the transfer case
__________________
59 chevy apache 31 4x4 - my project: http://67-72chevytrucks.com/vboard/s....php?p=8668512
53 buick special - straight 8 sled - blow through turbo
47 gmc - flatbed hot rod build
99 ford econoline e350 - 4x4 converted family roadtrip/overlanding rig AKA 'Monstervan' AKA 'Daddy-Van'
|