Thanks guys!
Some progress, doesn't look like much until you look at the floor...
Sometimes these louvers can be a challenge to sand.
In the spirit of "everything's a tool", a strip of 18 ga steel and a wrap of PSA paper does a good job of getting in the tight spaces.
Another shot of the scrap pile before I clean it up, this is what went into fabricating the escutcheons..
And now for the reason we didn't post earlier this week, had to make a speed run for Taco Tuesday.. even saw a full rainbow in the process.
https://www.youtube.com/watch?v=jWrIkyuUBTs
Back in the shop this weekend, but we had a distraction in another Meco torch that showed up for sale not three miles away. So needless to say about the only thing accomplished was more welding practice!!
https://www.youtube.com/watch?v=O9Wf1AbzP3c
After planishing...
https://www.youtube.com/watch?v=BDy82sixbjQ
.