The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

BIGglaSS · 12-24-2020, 04:26 PM

Does the oil pressure switch read actual PSI or on/off?

I can't figure out where the red/black wire goes. All diagrams online show the third wire as tan/white (not red/black), which might be pin 58 on the green block (58 TAN/WHT 332 Oil Pressure Sensor Signal)? it appears there used to be a pin in that location.

I'd like to add it back in if it will give oil pressure data to the gauge cluster. That's where I'm going to stick it unless someone tells me otherwise.

link to diagram: http://www.lt1swap.com/pictures/03to...e%20Sensor.gif

12-24-2020, 04:26 PM	#14
BIGglaSS Registered User Join Date: May 2014 Location: ID Posts: 663	Re: Lets get this LS 5.3 running! Does the oil pressure switch read actual PSI or on/off? I can't figure out where the red/black wire goes. All diagrams online show the third wire as tan/white (not red/black), which might be pin 58 on the green block (58 TAN/WHT 332 Oil Pressure Sensor Signal)? it appears there used to be a pin in that location. I'd like to add it back in if it will give oil pressure data to the gauge cluster. That's where I'm going to stick it unless someone tells me otherwise. link to diagram: http://www.lt1swap.com/pictures/03to...e%20Sensor.gif __________________ My museum of good intentions: 1957 3100 BBW restomod -- 1970 442 W30 Last edited by BIGglaSS; 12-24-2020 at 04:35 PM.